Human Hair Wigs Up to 51% OFF

How to detangle a wig?

When do wigs make you feel most depressed? If tangles cause you trouble, don’t worry too much. Many weavers have gone through this annoying experience and found a solution. How to mess up the wig? Is it role-playing, curly hair or wavy? Regardless of the hair unit, this blog post on Ms Aloe Lace Front wig can help you.

Before learning how to untie a wig, it is important to understand the root cause of tangles. Even if the wig is full lace, lace front or fully enclosed design, it may be more tangled than natural hair due to the following reasons.

Dry function

Your scalp produces natural oils. They protect your biological hair ease from drying out. At the same time, these oils will not be beneficial to your wig. This is why the fibers lack moisture and become more likely to twist into chaotic clumps.

How to arrange wigs made of human hair? The answer is below.

Step 1: Put the hair system on the shelf. Combing from root to tail becomes easier. The wig is very long and very important. What if there is no wig head? Then, put the items on the counter, etc.

Step 2: Use warm water to soak the wig in the sink for about 5 minutes. After that, wring out the excess water on the wig. Put it back on the wig head.

If the hair system is very dirty, you can add a few drops of shampoo to the water. Next, rinse off.

Step 3: Use conditioner to make hair easy to care for. To do this, pour one part conditioner and three parts room temperature waters into a spray bottle. Close the lid and shake well. Then, spray the solution onto the wig. Otherwise, rely on leave-in conditioner.

Step 4: Use a wide-toothed comb to slowly brush out the knots from the root to tip.

Step 5: Spray clean water on human hair and rinse. This method helps reduce the greasy feeling that remains when the wig dries.

Step 6: Let the device air dry. If you are in a hurry, you can rely on a hair dryer. In order to get the best hair protection effect, please set the cooling temperature or low heat.

Softeners provide moisture to synthetic fibers. This is why combing becomes easy. It also reduces gloss materials, making the appearance more realistic. For human hair units, washing with conditioner is sufficient.

Pour cold water into the basin. If the wig is too dirty, you can put it in warm water. Remember, don’t overheat your hair to prevent damage. Next, pour a softener cap for long wigs to water and form a mixture. For short hair units, please use a half caps.

Place the device in the solution for about 30 minutes. Don’t rub.

Wash off with cold water. Do not squeeze it, but raise it to remove the remaining water.

The fibers of the wet wig will adhere. So, don’t let it scare you. Just do it.

Use a towel to gently press the hair system. Doing so will allow water to absorb into your clothes. After no more dripping from the device, it is done.

Leave a Reply

Your email address will not be published. Required fields are marked *